The Lamp That Stops Your SIG Blomax From Throwing a Fit
Let’s be real. Your SIG Blomax line is a beast—it works hard, day in and day out. But when the lamps keep burning out and the fuses keep blowing, it feels like the machine is constantly throwing a tantrum, shutting everything down. We built this replacement heating lamp to break that frustrating cycle. It’s a tough, reinforced, drop-in solution made specifically for your SIG machine. It’s designed to handle the brutal, non-stop thermal shock of blow molding, so you can stop worrying and just keep producing.
Power and Fit: Made for the Job
We didn’t just throw a lamp together. We spec’d it to deliver steady, reliable heat exactly where the process needs it. The 400V rating means it gets the power it needs without the voltage dipping. That gives you a rock-solid thermal profile, which is essential for keeping the parison thickness consistent. And the 300mm heating length is a perfect match for the Blomax, so the heat hits the right spot, every single time.
The Inside Story: Built to Last
At its heart, it’s a high-purity quartz tube holding a halogen heating element. The quartz is what makes it tough enough to handle rapid heating and cooling without cracking. We also added a protective outer coating that manages the infrared radiation. This does two things: it spreads the heat better and shields the delicate filament inside. The R7s connector is a simple, two-contact design that just plugs right into your existing socket. And the whole thing is structurally reinforced to take the constant vibration and knocks of the factory floor—the very things that kill most lamps early.
What This Means for Your Line
When you put this lamp in, your Blomax gets back to doing what it was designed to do. No more scrambling to swap out parts. Your operators can focus on keeping the line moving, not troubleshooting. And because it’s built to last, you’ll spend less time managing spare parts and less time watching the machine sit idle.
A Quick Reality Check
Here’s the honest truth. This lamp is 400V and high-wattage because that’s what it takes to deliver the intense heat needed for demanding cycles. That means your machine’s cooling and electrical systems need to be in good shape. If the cooling can’t keep up, the area around the lamp will get too hot, and any heating element will burn out faster. But as long as your system is up to the task, this lamp will keep your line running strong.